Energotech ENC300 Instructions De Montage page 3

EnergoCassette ENC300, ENC360 and ENC600,
230V~, are intended for permanent installation
by an authorized electrician and in accordance
with existing national regulations. The appliance
must be preceded by an all-pole switch, min. 3mm
contact gap.
Appliance and protection class: Class I - IP55.
1. The EnergoCassette can be fitted into suspend-
ed ceilings with visible T-bars 15mm or 24mm,
fig.2, or fixed onto the ceiling using the supplied
H-bracket, fig.3. Lowest installation height is 1.8m
from floor level. Respect and follow the minimum
distances to the surrounding surfaces, according
to fig.1a. Fixed heater must not be mounted in
front of a socket outlet.
2. When mounting onto the ceiling, secure the
bracket first to the ceiling with three screws on
each side with distances C/C¹ and C/C², see fig.3
and table. Insert the ENC in the H-bracket by
hooking the fixings (B) into the fixing slots (A).
3. Let the ENC hang vertically, fig.4, and connect
the power supply cable to the 4mm² terminal block
in the connection box (C) according to fig.1b,
through the cable grommets (D).
4. Swing up, fig.4, and secure the heater horizon-
tally into the H-bracket, fig.5, with the two supplied
screws (E). Warning! Make sure that the fixings (B)
do not become unhooked at the opposite side.
5. If the ENC is to be mounted with chains or
wires, use the 4 existing fixings (B), as hanging
points, see fig.3.
6. When starting-up the heater for the first time or
after a long period of disuse, smoke or odor may
result from grease, dust or dirt that has collected
on the element. This is normal and disappears af-
ter a short period of time. Ensure the room/space
is well ventilated during this process.
7. Like in all electrical heating appliances, clicks
can occur during expansion and contraction of the
material due to movement when the temperature
changes.
8. The heater may undergo a color variation fol-
lowing being energized for the first time and during
its life span. The extent is relevant to the operating
environment and is normal behavior.
Aerosols, paint, solvents, dust and filth etc... may
adhere to the heater and can potentially cause
discoloration. The performance of the heater is un-
affected by discoloration. As a precaution, always
switch off the heater while painting and drying!
9. Information about energy consumption
In combination with an Ecodesign-compliant
thermostat, the product data complies with the EU
regulations on the Ecodesign Directive (2009/125/
EC) for energy-related products (ErP).
10. Safety
• When the installation is protected by an RCD, a
300mA residual current device has to be used.
• Warning - Hot surface! Do not touch the heater
when in use!
• Do not cover the heater! Risk of fire!
• This appliance shall not be used by children
less than 8 years or persons with reduced
physical, sensorial or mental disability or lack
of experience and knowledge, unless they are
supervised or were instructed how to use the
appliance in a safe way, and understand the
hazards involved.
ErP