Remote Control - S&P HUMI-E D Notice D'installation Et D'utilisation

M A X- M IN
4.-
light columns
(Maximum/Medium/Minimum)
If the RH of the room is below the desired RH, select the maximum flow.
5.-
T IM ER
between 1-12 hours. After this time, the unit will stop automatically.
The display will intermittently indicating the remaining time.
6.-
When the water tank is empty, the same symbol flashes and the appliance emits an
audible warning signal.
Note : It is recommended to clean the appliance following the recommendations in the
section MAINTENANCE, before filling the water tank again.

5. REMOTE CONTROL

Using the remote control, you can control and program the humidifier.
-
Before using the remote control for the first time, remove the plastic film that protects
-
the battery.
Always point the remote control at the receiver located at the front of the screen.
-
The remote control can work at a distance from the receiver up to about 3 metres,
-
always check there are no obstacles that distort communication.
Ensure that the battery of the remote control is correctly located. When replacing the
-
battery, make sure it is the same type.
The remote control should not be exposed to shock, moisture and prolonged
-
exposure to sunlight.
Do not misuse the remote control.
-
6. MAINTENANCE
-
Before any cleaning or maintenance on the appliance, disconnect the appliance from
the mains.
- Clean all areas that come into contact with water regularly (twice a week) with a damp
cloth, including the transducer and the steam generation pipe. Do not use detergents as
they could damage the transducer.
- How to clean the transducer : Place 5-10 drops of vinegar on the transducer and wait
10 minutes. Using a small brush, remove lime scale carefully. Then finish with clean
water.
By MAX-MIN control, you can select three humidity flow rates. The two
of the display
With TIMER control, you can program the device operating time
When the water tank is empty, this symbol appears in the display.
indicate the
11
selected flow rate