Publicité
Les langues disponibles
Les langues disponibles
Photo 2
Rubbers maintaning of the inner
of the fairing
Fitting screws of the screen
To unclip
Fitting kit
- 4 M10 steel washers
Assembly
- Remove the 4 inners fairing (photo 1). Remove and disconnect the mirrors. Remove the screen on its
upper side.
- Unhook the original screen on the 2 outside corners (see photo 2).
- Unhook the whole "screen / front fairing" by pushing it towards the bottom of the bike.
- Remove the front side and maintaining rubbers of the inners fairing, and replace the whole as
indicated on the photo 2.
- Replace the unit on the bike and fit the screen thanks to the original screws and the provided washers
(see photos 3 and 4).
- Replace and connect the mirrors. Replace the inners of the fairing.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
FITTING INSTRUCTIONS
ERMAX "AEROMAX" SCREEN
ADAPTABLE ON VFR 1200 2010 → ∞
Photo 3
Location of the inners fairing
« CAUTION »
Estimated fitting time : 1 hour
Photo 4
Photo 1
Publicité
