Grounding Instructions; Important Hot Blending Instructions; Operating Instructions - Waring PRO WPB Mode D'emploi

13. To avoid injury, never place blade assembly on the base
without container properly attached.
14. Always operate blender with cover in place.
15. When blending hot liquids, remove center piece of
two-piece cover. Begin processing with only one cup
(8 oz.). Always begin processing at the lowest speed
setting. Keep hands and other exposed skin away from the
lid opening to prevent possible burns. See Hot Blending
instructions, next page.
16. Screw on container bottom firmly. Injury can result if
moving blades accidentally become exposed.
17. Do not leave blender unattended while it is running.
18. Do not operate your appliance in an appliance garage
or under a wall cabinet. When storing in an appliance
garage, always unplug the unit from the electrical
outlet. Not doing so could create a risk of fire, especially if
the appliance touches the walls of the garage or the door
touches the unit as it closes.
SAVE THESE INSTRUCTIONS

GROUNDING INSTRUCTIONS

For your protection, Waring Pro
with a 3-conductor cordset that has a molded 3-prong
grounding-type plug, and should be used in combination with a
properly connected grounding-type outlet as shown in Figure 1.
If a grounding-type outlet is not available, an adapter, shown in
Figure 2, may be obtained so that a 2-slot wall outlet can
be used with a 3-prong plug. Referring to Figure 3, the adapter
must be grounded by attaching its grounding lug under the
screw of the outlet cover plate. CAUTION: Before using an
Blenders are equipped
®
4
adapter, it must be determined that the outlet cover plate screw
is properly grounded. If in doubt, consult a licensed electrician.
Never use an adapter unless you are sure it is properly
grounded.
Note: Use of an adapter is not permitted in Canada.
This appliance is for 120 volts only and should not be used with
a converter.
IMPORTANT: HOT BLENDING INSTRUCTIONS
To minimize possibility of scalding when blending hot
ingredients, the following precautions and procedures must be
observed:
1. Limit amount of material processed to one cup (8 oz.).
2. Completely remove the lid insert of the two-piece container
lid before starting motor. (This will allow venting of the
rapidly heated and expanding air present inside container
when blender is running.)
3. Start blending on low speed.
4. While blender is running, up to 1½ cups (12 oz.) of
additional liquid can be added. Pour liquid slowly through
the opening in the lid.

OPERATING INSTRUCTIONS

1. When placing the container on the unit base, make sure
that the unit is turned off and is at a complete stop. Do not
put the container on or take it off while the unit is running.
Doing so may damage the drive shaft or blade assembly.
For best results, do not fill container above
3-cup level.
2. Be sure the switch is in the off position and plug the
blender into a convenient outlet.
3. The Waring Pro Blender is ideal for blending ice drinks.
®
A hint when mixing ice drinks: keep the blades in the
container covered with liquid, turn the unit on, remove the
lid insert on top of the jar lid, and feed the ice cubes slowly
into the jar. NOTE: Never use containers other than Waring
Pro Blender containers with your Waring unit.
®
5