Hama 00096017 Mode D'emploi page 4

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions
and information completely. Please keep these
instructions in a safe place for future reference. If
you sell the device, please pass these operating
instructions on to the new owner.
Controls
A) LED strip
1. ON/OFF switch
2. USB connector
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety
instructions or to draw your attention to
specific hazards and risks.
Note
This symbol is used to indicate additional
information or important notes.
2. Package Contents
• LED strip (2x 50 cm) with ON/OFF switch
• These operating instructions
Note
Please check that the set is complete before
using it and ensure that none of the parts is
faulty or damaged.
3. Safety Notes
• Protect the product from dirt, moisture and
overheating, and only use it in a dry environment.
• The product is intended for private, non-
commercial use only.
• Use the product for its intended purpose only.
• Do not use the LED band while it is still in the
packaging or when it is rolled up.
• Do not operate the product outside the power
limits given in the specifications.
2
• Always pull directly on the plug when
disconnecting the cable, never on the cable
itself.
• Lay all cables so that they do not pose a tripping
hazard.
• Do not bend or crush the cable.
• Do not drop the product and do not expose it to
any major shocks.
• Be careful not to bend the LED band. This can
cause damage to the band.
• Do not connect the product to other lighting
systems.
• Do not open the device or continue to operate it
if it becomes damaged.
• Do not attempt to service or repair the product
yourself. Leave any and all service work to
qualified experts.
• Keep this product, as all electrical products, out
of the reach of children!
• Dispose of packaging material immediately
according to locally applicable regulations.
• Do not modify the product in any way. Doing so
voids the warranty.
4. Operation
• Connect the USB connector (2) to a USB port on
your television.
• Alternatively, you can also connect the USB
connector (2) to a USB charger or to another
terminal device with USB port.
Note - Connecting to terminal devices
• Before connecting to a terminal device, check
whether the power output of your terminal
device can supply sufficient power for the
LED band.
• For more information, please refer to the
operating instructions of your terminal device.
If necessary, ask the relevant manufacturer's
support centre for the information you need.
• Remove the protection foil from the rear of the
LED band to fasten it to your television, wall, etc.
using the self-adhesive strip on the rear.