Balluff BIW1-A310-M P1-S115 Série Notice D'utilisation page 12

BIW1-A/C/E/G310-M_ _ _ _-P1-S115
Micropulse Linear Transducer in Profile Housing
4 Wiring (cont.)
When routing the cable between the
transducer, controller and power
supply, avoid proximity to high volt-
age lines to prevent noise coupling.
Especially critical is inductive noise
caused by AC harmonics (e.g. from
phase-control devices), against
which the cable shield provides only
limited protection.
Cable length max.
Ø 6 to 8 mm. Longer lengths may
be used if construction, shielding
and routing are such that external
noise fields will have no effect on
signal integrity.
Pin numbering for connector
6
view of BIW side
7
1
Fig. 4-2: Pin arrangement BKS on
BIW
A/G 25 m
M12×1
C/E 100 m
BKS-S115-PU-_ _
5
4
straight
BKS-S115
3
8
2
Fig. 4-3: Connector (optional)
Fig. 4-4: Outgoing cable
BKS-S116-PU-_ _
M12×1
BKS-S116-PU-_ _
Ø 6 - Ø 8
Cable Entry
(PG 9 fitting)
M12×1
Ø 20
5
english