Assembly Procedure - Bartscher 601.710 Notice De Montage

Assembly Procedure:

Step 1
Place the round plastic blockades (D) inside the
slots in the posts (C) at the desired height, with the
small, narrow end of the plastic blockades (D) at
the top.
The plastic blockades (D) allow for changes of
height at intervals of 2.5 cm, and the thicker end
of a blockade (D) should be located at the
bottom. We recommend placing the bottom shelf
(B) not higher than 15 cm above the floor.
Step 2
Insert the four posts (C) into the corners of the
bottom shelf (B) and slide along until reaching the
plastic blockades (D).
Adjust and level out the table, then press on the
bottom shelf (B) to ensure it is securely fixed in
the plastic blockades (D).
- 8 -