Samsung BRB2601 Serie Guide D'utilisation page 34

Installation
STEP 5 Initial settings
By completing the following steps, the refrigerator should be fully functioning.
1. Remove the PE foam sheet on each shelf corner, which is attached to protect the
refrigerator during transportation.
2. Open the door, and check if the interior light lights up.
4. Set the temperature to the coldest, and wait for about an hour. Then, the freezer will be
slightly chilled, and the motor will run smoothly.
5. Wait until the refrigerator reaches the set temperature. Now the refrigerator is ready
for use.
NOTE
When the refrigerator powers on, the alarm will sound. To turn off the alarm, press Freezer
or Fridge.
STEP 6 Temperature Alarm (applicable models only)
Type 1
• The refrigerator blinks '- -' on the temperature display with an alarm if the freezer
compartment is too warm. This may occur if the freezer becomes too warm after there
has been a power failure.
• If this happens, press Freezer or Fridge. Whichever warmer temperature is displayed
for 5 seconds. Then the actual temperature is displayed. To deactivate the alarm, press
Door Alarm.
Type 2
• The refrigerator blinks the temperature indicator with an alarm if the freezer
compartment is too warm. This may occur if the freezer becomes too warm after there
has been a power failure. To deactivate the alarm, press Freezer or Fridge.
STEP 7 Final check
When installation is complete, confirm that:
• The refrigerator is plugged into an electrical outlet and grounded properly.
• The refrigerator is installed on a flat, level surface with a reasonable clearance from the
wall or the cabinet.
• The refrigerator is level and is sitting firmly on the furniture.
• The door opens and closes freely, and the interior light turns on automatically when you
open the door.
34 English
Untitled-9 34
3. Remove the PE foam on the magnet
from the top of the door.
2017-01-31 6:54:50