Honeywell HZ-725 Série Guide D'utilisation page 3

Fig. 2
OPERATION
NEVER LEAVE AN OPERATINg UNIT UNATTENDED
1. Place heater on stable, level surface 3 ft. (0.9M) away from any combustible materials (furniture, drapes, etc) (Fig. 3).
2. With the knob in the OFF position, plug the heater into an electrical wall outlet (Fig. 4).
3. Turn the thermostat knob fully clockwise to the HIGH setting (Fig. 5).
Fig. 3
4. To turn the heater on, turn the power knob clockwise to the ON position. Please note, this is a silent heater so you will not hear
a fan noise when it is on (Fig. 6).
5. When the room reaches a comfortable temperature, slowly turn the thermostat control counter-clockwise until the heater
goes off and you hear a click. This is the point which the thermostat setting equals the room temperature. At this setting, the
thermostat will automatically turn the heater on and off to maintain the desired temperature (Fig. 7).
6. This heater uses natural convection technology where heat is emitted out of the top of the grille, naturally rises and then
circulates throughout the room to create warm even heat (Fig. 8).
Fig. 6
Fig. 4
Fig. 7
-  -
Fig. 5
Fig. 8