System Maintenance; Changing The Remote Control Battery - Chrysler Mopar Guide De L'utilisateur

System Maintenance

Changing the Remote Control Battery; Mopar part # 05140773AA (2 required):
The two 3-volt lithium batteries (CR-1220) supplied in your remote control should
last approximately one year, depending on usage. When the batteries begins to
weaken, you will notice a decrease in range (the distance from your vehicle that
your remote transmitter will operate). Follow the instructions below to change the
remote transmitter battery.
1. With a small flathead screwdriver, carefully pry the two halves of the remote
transmitter apart.
2. Gently pry the transmitter circuit board out of the case.
3. Slide the black battery holder out of the bottom of the circuit board. Do not lose
the black battery holder.
4. Remove the old batteries and replace with new ones. Observe the (+) and (-)
signs when removing the old batteries.
5. Gently snap the circuit board back into the transmitter case.
6. Carefully snap the case halves back together, then test the remote control.
It is not necessary to re-program the remote control after changing the
battery.
5