Putting Into Service; Using The Machine; Basic Settings; Operating - HAEGER Black Mist HF-18R.001A Mode D'emploi

English

Putting into Service

Electrical Connection
1. Connect the device to a duly installed 220-240V~50/60Hz protective contact socket.
2. Before inserting the plug into the socket. Make sure that the mains voltage to be used
matches that of the device. You can find this information on the nameplate.
Fitting batteries into the remote control (Batteries not supplied)
Open the lid of the battery compartment on the rear of the remote control.
•
Insert 2 MICRO batteries of type R03 "AAA" 1.5 V.
•
Please ensure the correct polarity. Details can be found in the battery compartment.
•
Close the battery compartment.
•
NOTE:
If you are not going to use the remote control for a prolonged period, remove the batteries in
order to prevent them from leaking.
CAUTION:
Used batteries should not be disposed of in the domestic waste. Please return all
•
batteries to a special collection point.
Different types of battery or new and used batteries must not be used together.
•

Using the machine

Basic Settings

Set the blower inclination angle before starting the device. You can adjust the inclination angle
by tipping the blower casing with both hands. The inclination angle amounts to approx. 10°.

Operating

You can operate the appliance using the remote control as well as the touch buttons on the fan
body housing. The functions are identical.
NOTEs:
1. The LED on the switch housing indicates the settings.
2. The remote control should be pointed towards the fan when using. If the remote does not
work, please replace the batteries and retry.
This will switch all the functions off. To turn off the screen, simply press the 'off' button
for 3 seconds.
4 Instructions for use