Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-0000000076-003.book Page 15 Monday, September 23, 2019 9:51 AM
Working instructions.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
For each job, use only the FEIN application tool released and intended for the respective
application.
Switching on and off (figure 5).
Check the power supply cable
WARNING
and the plug for damage.
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
Guide the power tool toward the work
piece only when switched on.
Switching on without lock-on function:
Press the safety lock and the On/Off switch
(I) at the same time.
Release the safety lock again.
Switching off:
Release the On/Off switch ().
Guide the power tool uniformly and with
light feed in the cutting direction. Excessive
feed considerably reduces the tool life of the
application tools.
To increase the tool life of the saw blade
when cutting metal, it is recommended to use
a lubricant via the lubricating device in the
gearcase:
– For cuts in steel sheet: cutting oil
– For cuts in aluminum: petroleum.
en
15
Publicité
