Safety Instructions - Belle TUBMIX 50 Mode D'emploi

SAFETY INSTRUCTIONS

Warning! When using electric tools, the following
safety precautions should always be followed to reduce
Read and follow all these instructions before attempting
to operate this product and save them with care!
SAVE THESE INSTRUCTIONS WITH CARE.
Keep your work area perfectly clean
- Cluttered areas invite injuries.
Consider work area environment
- Don't expose tools to rain.
- Don't use tools in damp or wet locations. Keep
work area well lit.
gases.
Guard against electric shocks
- Prevent body contact with grounded surfaces.
Keep children away!
- Do not let third parties contact tool or extension
cord. All visitors should be kept away from work
area.
Store your tools in a save place
- When not in use, tools should be stored in dry and
save places, out of the reach of children.
Don't force tool
- It will function better and in a safer way at the rate
for which it was intended.
Use the right tool
- Don't use low duty tools or accessories to do the
job of a heavy-duty tools. Don't use tools for
purposes not intended.
Dress properly
- Rubber gloves and non-slip footwear are
recommended when working outdoors. Wear
protective hair covering to contain long hair. Use
safety glasses.
- Use a mask if working operations are dusty.
Don't abuse cord
- Never carry tool by cord or yank it to disconnect it
from socket.
- Keep cord from heat, oil and sharp edges.
Avoid unsteady positions
- Be sure to work in a safe and balanced position.
Maintain tools with care
- Keep tools sharp and clean for better and safer
performance.
- Follow all maintenance advice and instructions to
replace accessories subject to wear. Inspect tool
cords periodically and, if damaged, have them
repaired by an authorised expert. Check extension
cords periodically and replace them if damaged.
Keep handles dry, clean and free from oil and
grease.
Disconnect tools
- When not in use, before servicing, and when
changing accessories subject to wear.
Remove service keys from tool
- Form the habit of checking to see that keys and
adjusting wrenches are removed from tool before
turning it on.
Avoid unintentional starting
- Be sure that the switch is off when plugging in the
tool.
Extension cords for outdoor works
- When tool is used outdoors, use only extension
cords intended for this particular use and so
marked.
Stay alert
- Watch what you are doing. Use common sense.
Do not operate tool when you are inattentive.
Check tool for damaged parts
- Before further use of the tool, check it and the
safety devices for damages and be sure that they
operate properly. Check for functioning and
binding of moving parts, breakage of parts, correct
mounting, and any other conditions that may affect
the correct operation of the tool.
- Damaged safety devices or other parts should be
properly repaired or replaced by an authorised
Service Centre unless otherwise indicated
elsewhere in this instruction manual.
- Have defective switches replaced by an
authorised Service Centre.
- Do not use tool if its switch cannot be turned on or
off.
Warning
- For your personal safety use only accessories
recommended in this instruction manual or in the
relevant catalogues. The use of any other
accessory or attachment other than those
recommended in this instruction manual or in the
relevant catalogue may present a risk of personal
injury.
- This electric appliance is in accordance with the
carry out repairing of electric appliances otherwise
carry out repairing of electric appliances otherwise
it may cause considerable danger for the user.
9
GB