Using The 3D Function; Changing The Mode - Samsung 4 450 Série Guide De L'utilisateur

Using the D Function
You can enjoy D movies and games on your TV. The D effects function enables you to view D images using
special D glasses.
Connections
D Glasses
(Not supplied)
※ The appearance of the 3D glasses (including Emitter) may differ depending on the model of your glasses.
1 Connect a HDMI/DVI cable between the HDMI IN 2 jack on the TV and the PC output jack on your computer.
 Connect a 3.5mm Stereo/2RCA cable between the DVI IN (HDMI 2) [R-AUDIO-L] jack on the TV and the Audio
Out jack of the sound card on your computer.
 Connect the Emitter to the 3D SYNC OUT port on the rear panel of the TV.
4 Turn the TV on and set the source of the TV to HDMI2.
➢ For more information on the 3D glasses (including the Emitter), refer to the user manual of your 3D glasses.
Adjust the PC resolution: - PN42A450P1D: 1024 x 768@60Hz
➢
Optimum PC resolution for PN50A450P1D is 1360x768. When 1024x768 signal is connected in 3D mode, the picture
➢
will be shown in 4:3 format with left and right side grey bars appeared.
The 3D IR Emitter communicates with the 3D glasses.
➢
Therefore, the 3D IR Emitter should be located near the 3D glasses.
➢ It is activated when the HDMI or DVI input signal is RGB, and DVI Sound is supported.
➢ When the power is turned on or off, the mode changes to the default (Off) and the Format is saved.
➢ The D Effect is turned on or off regardless of the Picture Mode.
When D Effect is on, only the Contrast, Brightness, D Effect, and Reset picture menus are activated.
➢
➢ To use the 3D Effect function, a graphics card supporting 3D or 3D software is required.
The 3D glasses and the Emitter must be manufacturer by the same company.
➢
➢ If you play a game or watch TV while wearing the 3D glasses for long periods of time, you may experience eyestrain or
a headache.
➢ 3D glasses (including the Emitter) not manufactured by Samsung may not be supported.
If you fi nd the screen fl ickering while the 3D function is used, change the environmental lighting darker or turn off the
➢
fl uorescent lamp to watch the screen for its best condition.

Changing the Mode

Provides the function to turn on the 3D Effect. You can choose between Mode1 and
Mode2. To achieve the 3D effect, the 3D glasses shutter back and forth from the left
to right and vice versa (left/right sync).
1 Connect the TV, PC and 3D IR Emitter as shown in the fi gure.
 Press the SOURCE button to select HDMI.
 Press the MENU button to display the menu.
Press the ▲ or ▼ button to select Picture, then press the ENTER button.
D IR Emitter
(Not supplied)
- PN50A450P1D: 1024 x 768@60Hz,1360 x 768@60Hz
English - 
PC
 .5 mm Stereo plug to  RCA Cable (Not supplied)
1 HDMI/DVI Cable (Not supplied)
Continued...
TV Rear Panel
T V Picture
Mode : Standard
Cell Light
Contrast
Brightness
Sharpness
Color
Tint G 50
More
▼
Move Enter
►
7
95
45
50
50
R 50
Return