1. Remove filters
3. If using a cable lock, pry open the
desired electrical knockout either on
top or back of hood. Feed the wires
through the cable lock. Some local
codes require the use of a cable lock,
check your local codes.
5. Remove starting collar from inside
hood body and secure 3-1/4" x 10"
rect. starting collar to the top or rear
duct opening using (10) M3.5x12
screws.
2. Remove cover from junction box to
gain access to electrical wiring.
4. If using hood in air recirculating
mode skip steps 4 and 5.
Pry open desired ducting knock-out
either on top or back of hood.
5. Remove starting collar from inside
hood body and secure 6" round start-
ing collar to the top duct opening using
(10) M3.5x12 screws.
10