Modes Of Use (Precision-Gliss) - BaByliss Homelight 100 Mode D'emploi

NB: The appliance has a mechanism to protect your eyes, a contact sensor that prevents the appliance from
releasing a pulse if its application surface is not in full contact with your skin. If the appliance is not in full
contact with your skin, it will not release a pulse of light. Make sure, therefore, that the application surface
is correctly applied to your skin.
8. Press the release mechanism. The appliance will release a pulse of light. You may feel a slight warm and
tingling sensation.
9. Remove the application surface from the treated patch of skin.
10. Move the application surface to another area to be treated. Pressure marks left on your skin by the
application surface should help you to correctly align the epilator to administer the next pulse, avoiding
the release of two pulses on the same patch of skin or too much space being left between the patches.
(see 'Covering the area to be treated'). Your Homelight appliance will recharge immediately after each
pulse. After 1,6 second (at level 1), the 'ON/OFF/READY' indicator light will come on again. The appliance
is now ready to release another pulse.
6.4. Modes of use
PRECISION mode
The Precision Mode, as described under points 7 to 10 above, allows for safe treatment of the least
accessible and most sensitive areas of your body (face, underarms, bikini line, etc.).
GLISS mode
When the applicator window is properly applied to the skin and the release mechanism is held in, the user
can activate the Gliss mode (continuous release of 36 pulses per minute, at level 1). In this way, there is an
automatic continuous release of pulses without the need for additional handling. You can thus easily slide
the appliance over your skin without interruption in a slow and continuous movement without lifting or
lowering it.
IB_G932-34E.indd 49
Warning: Never treat the same patch of skin more than once per depilation session!
Repeated treatment of the same area increases the risk of side effects.
49
5/13/14 1:02 PM