Troubleshooting; Hints On Disposal; Declaration Of Conformity - oneConcept 10029282 Mode D'emploi

Problem
No water/no steam.
No lipa.
No steam.
Coffee maker can't work any
more, hot water & steam lamp
are on, another two lamps not.
Coffee more or less.
The steam cannot froth.
According to the European waste regulation 2002/96/EC this symbol on the product
or on its packaging indicates that this product may not be treated as household
waste. Instead it should be taken to the appropriate collection point for the recycling
of electrical and electronic equipment. By ensuring this product is disposed of cor-
rectly, you will help prevent potential negative consequences for the environment
and human health, which could otherwise be caused by inappropriate waste hand-
ling of this product. For more detailed information about recycling of this product,
please contact your local council or your household waste disposal service.
Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany.
This product is conform to the following European Directives:
2004/108/EC (EMC)
2011/65/EU (RoHS)
2006/95/EC (LVD)

Troubleshooting

Possible Cause
No water inside the tank.
Tank is not located well.
Preheating is unfi nished
Coffee powder is too thick.
The steam hole was blocked.
Not closed steam knob.
Coffee powder loading is too
much or less.
Is it whole milk?
The steam ready indicator is
not illuminated, then begins to
frothing milk.

Hints on Disposal

Declaration of Conformity

Solution
Will be adding water into the
water tank, Switch on the
power switch and coffee switch.
Change the coffee powder.
Use a small wire to poke the
steam holes.
Closed steam knob
1 cup 1 spoon with fl atten
according to the standard
amount of fi lling. Too thick
coffee powder can not be
complete extraction, too fi ne
affect the quantity of coffee
Use cold whole milk.
Only after the steam ready
indicator is illuminated, the
steam can be used to froth.
13