Safety Instructions; Kit Contents - Ring Automotive RBS100 Instructions

Instructions for Ring Automotive
Borescope Inspection Camera (RBS100, 200, 300)

1. SAFETY INSTRUCTIONS

This manual contains important information about the operation of this product. Failure to comply with the
instructions can cause electric shock, fire or serious injury. Responsibility will not be accepted for damage to
persons or property caused by failure to follow the operating instructions.
• Always use appropriate protective equipment such as safety glasses and gloves while handling and using the
inspection camera.
• Only the inspection probe is waterproof, do not expose the main display unit to moisture.
• Do not immerse the inspection probe in more than 90 cm of liquid. Observe the marking on the flexible shaft
for this purpose.
• Do not stare directly into the LED light.
• Do not place the inspection camera anywhere that may contain a high voltage or moving parts.
• Do not expose the device to excessive mechanical stress or vibration.
• Do not bend the flexible shaft further than the specified minimum bending radius shown in the specification.
• Do not use this device for personal inspection or medical use in any way. This is not a medical device and such
use could cause personal injury.
• Always ensure equipment or machinery is switched off before inspection.
• Exposure of batteries to high temperatures can cause them to explode.

2. KIT CONTENTS

A. Inspection Camera & Display
B. Video Cable
C. USB cable (RBS200/300 only)
D. Hanging Hook
E. Clip-on Tools (RBS100/200 only)
F. 4 x AA Batteries (RBS100/200 only) or
1x Lithium Ion Battery (RBS300 only)
G. Battery Charger (RBS300 only)
H. Micro SD card (RBS200/300 only)
B
C
A
D F
E
2
or
RBS200: 512MB
RBS300: 2GB
G
H