Signalink USB Manuel D'installation Et Fonctionnement page 26

3. You should now see a volume control window similar to the one shown below. Note that
the Applications volume control will display the name of your communication program (or
something similar), and that it may not be visible unless your program is transmitting.
you do not see the Applications volume control, then you will need to put your program in
Transmit and re-open this window.
4. If you are using the SignaLink USB, then you should adjust the Speakers and Applications
controls as shown above. Note that the Speakers control MUST be set to 100%, and the
Applications control MUST be set to 50%. If they are not set correctly, then the SignaLink
USB's PTT LED will not turn ON, and you will not be able to Transmit.
5. If you are using the SignaLink SL-1 or SL-1+, then please note that the "Speakers" and
"Applications" controls shown above are the equivalent of the "Master Volume" and the
If