Motor Maintenance - FRIMEC F6CCY35BR Manuel D'instructions

Step 4: Adjust the air inlet direction
(From rear side to under-side.)
1. Take off the ventilation panel and flange.
Ventilation panel
2. Change the mounting positions of the
ventilation panel and air return flange.





Air return flange
3. When installing the filter mesh, fit it into the
flange as illustrated in the following figure.
NOTE: All the figures in this manual are for
demonstration purposes only. The air conditioner
you have purchased may be slightly different in
design, though similar in shape.

Step 5: Fresh air duct installation
Dimension:
Air return flange
Fig. 4.11
Ventilation panel
Fig. 4.12
Pump maintainance:
Fig. 4.13
1. Remove four screws from the drain pump.
2. Unplug the pump power supply and water
3. Detach the pump.
12
Duct joint for fresh air
MODLE
18-60
Ø .
Step 6: Motor and drain pump maintenance
(the rear ventilated panel is used as an example)

Motor maintenance:

1. Take off the ventilated panel.
2. Take off the blower housing.
3. Take off the motor.
level switch cable.
Ø160mm .
Fig. 4.14
Mofor
Blower housing
Ventilated panel
Fig. 4.15
Pump
Fig. 4.16
V.1