Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Cleaning and Maintenance
•
Before cleaning the appliance, disconnect it from the
outlet and let it cool down.
•
To clean the outer shell, wipe it often with a soft sponge.
For very dirty parts, wipe with a sponge dipped in < 122°F
water and mild detergent, then dry the heater enclosure
with a clean cloth. Be careful not to let the water enter the
inside of the appliance.
•
To protect the enclosure, do not splash water onto the
heater, and never use a solvent like gasoline, isoamyl
acetate, toluene, etc. to clean the heater.
•
Do not immerse the heater in water.
•
Wait until heater is dry before use.
Problem
Fan speed stays the same when changing settings.
Heating element does not glow red.
Do not feel heat or air flow.
4
LED Light Operation
•
!
USB Outlet
•
TROUBLESHOOTING
Cause
1.
Fan speed stays constant. Setting changes amount
of heat output only.
1.
Heating element is made of stainless steel and
will not glow red to produce heat.
1.
No power to heater.
2.
Desired room temperature reached.
3.
High limit switch has been reached.
Aim LED light at the object you wish to illuminate. Set the
LED light switch to ON.
WARNING: Eye damage. Never look directly into light
sources or LED chips. An LED is extremely bright and can
damage eyes with prolonged exposure..
USB plug adapts to 1A-2A output, which is perfect for
mobile phones, tablets, and speaker systems. Be sure unit
being charged is not in front of the heater.
1.
Heater is operating correctly.
1.
Heater is operating correctly.
1.
Check power connections / connect heater to
power supply.
2.
Thermostat will shut off once desired room
temperature is reached. Heater is operating
correctly.
3.
Unplug the unit and let sit for 10 minutes.
Solution
Publicité
Table des Matières
