Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
Base
1. Connect the modular end of the AC power adapter to the
power jack of the base, and then plug the AC adapters into
a standard AC wall outlet.
2. Connect one end of the phone line cord to the phone line
jack of the base, and the other end to a standard phone wall
outlet.
This terminal is designed to be connected to the main power 100/240V 50/60Hz through
a power adapter supplied with the unit and to the analog telephone network TNV3 as
defined in standard EN 60950 amendments 1 to 11.
EN
Basic functions
Making a Call
Pick up the handset and press the
-
Dial the telephone number.
-
To end the call, press the
key.
-
Predialing: You can enter the desired phone number in standby mode, which allows you
to make corrections before dialing. Enter a telephone number (up to 32 digits). Check it.
You can also use the
key to insert a pause. When the number appears correctly,
press the
key.
Receiving a call
When a call is received, the "New Call" information will appear on the LCD.
If the caller can be identified, the caller's phone number is displayed. If the caller cannot
be identified, only the "New Call" information displays.
EN
49/79
key, the
icon appears on LCD.
51/79
Handset
The rechargeable Ni-MH batteries (AAA size,
1.2V, 600mAh) come with your phone. Install
the batteries before use.
- Slide the battery cover in the direction of the
arrow and pull it out.
- Insert new batteries as indicated, matching correct polarity (+,-).
When replacing the batteries, always use good quality Ni-MH re-chargeable batteries.
Never use other batteries or conventional alkaline batteries.
Before initial operation, you should fully charge the handset for about 15 hours.
To charge the handset, you should place it on the base. When you place the handset on
the base, the handset automatically turns on.
To turn the handset on, press and hold the
To turn off the handset, keep the
key pressed until the display disappears.
EN
To answer the call, press the
key. If you have activated the Auto Answer function
(see page 72), when the handset is on the base, simply lift it up to answer.
Ringer volume: You can select the ringer volume by using the
phone rings with an incoming call.
Adjusting Voice Volume
During a conversation, you can use the
(or the handsfree speakerphone one, if activated) volume from V.1 to V.5. The selected
volume will be displayed on the LCD.
You can also select the earpiece volume or the speaker volume by the Audio Setup in
Menu under HS Settings, as described in page 69.
Handsfree
During a call, you may turn on the speakerphone built in the handset. Press the
key, the
icon appears on the LCD. To turn the feature off, press the
and the
icon will disappear.
EN
key until the display is switched on.
50/79
or
key when the
or
key to adjust the level of the earpiece
key again
52/79
Publicité
Table des Matières
