Samsung NX58H5650WS Manuel D'installation page 31

Step 4. Install the anti-tip device
To reduce the risk of tipping, the appliance must be secured by properly
installing the anti-tip device packed with the appliance.
WARNING
• All ranges can tip, resulting in personal injury.
• Tipping ranges can cause burns from spills, personal injury, and/or death.
• To prevent accidental tipping, install and check the anti-tip bracket
An anti-tip bracket and screws,
installation instructions, and template
are shipped with every range (PN
DG94-00870B). The instructions include
information necessary to complete the
installation of the anti-tip bracket. Read
and follow the instructions on the sheet
and use the template for anti-tip bracket
installation. If not properly installed, the
range could be tipped by you or a child
standing, sitting, or leaning on an open oven door.
To install an anti-tip bracket, release and extend the leveling leg to a
minimum clearance of 21/32 in (16.5 mm) between the range bottom and
the floor.
To check if the bracket is installed and engaged properly, remove the warming
drawer or storage drawer and look underneath the range to see that the leveling
leg is engaged in the bracket. Carefully tip the range forward. The bracket should
stop the range within 4 inches (10.2 cm) of tipping. If it does not, the bracket
must be reinstalled.
If the range is pulled from the wall for any reason, always repeat this procedure
to verify the range is properly secured by the anti-tip bracket. Never completely
remove the leveling legs or the range will not be secured to the anti-tip device
properly.
(Install)NX58H56_DG68-00524A_EN+CFR.indb 31
following the instructions and template supplied with the bracket.
installation instructions _31
08/02/2014 11:54:49