Abus Security-Center AZ4210 Instructions D'installation page 8

3. Components and Wiring
1.) PROG
As a factory default, the PROG jumper is plugged off. When the jumper
is placed, an extented BUS protocol will be transmitted to the panel.
Note:
The mains power LED lights up when 12V is connected. A main fault is
shown as an alarm on the operating panel.
2.) LED MIMIC
If this jumper is connected, the red LED of the operating panel lights up
when the output is switched. As a factory default, the output is set to
"Pending", where the LED lights up if there are two alarm messages.
Remove the jumper if the LED is not to be used.
3.) ADDRESS
Change the address of the operating panels to 1, 2, 3 or 4 by
connecting the individual jumpers. If you do not connect the jumper,
this defines address 5. The number of operating panels depends on the
type of wiring and the network number. For further information, see the
installation instructions.
8