What Are Included; Unpacking Instructions; Technical Parameters; Product Description - BEKA DMX RGB Série Manuel D'utilisation

User manual
1. BEFORE YOU START

1.1 What are included

1 – DMX RGB Controller
1 - Manual

1.2 Unpacking Instructions

Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all
parts are present, and have been received in good condition. Notify the shipper immediately and retain
packing material for inspection if any parts appear damaged from shipping or the carton itself shows
signs of mishandling. Save the carton and all packing materials. In the event that a fixture must be
returned to the factory, it is important that the fixture be returned in the original factory box and packing.
2. USAGE
2.1

Technical Parameters

• Working temperature: -20-60 °C
• Supply voltage: DC12-24V
• Output: 3 channels – 4 channels
• Output current: each channel 8A
• Out grayscale: 256
• Connecting Mode: Common anode
2.2

Product Description

DMX Decoder controller adopts the advanced micro control unit, it receives standard DMX-512 digital
control signal and transformed it into PWM signal for driving LED; You could connect DMX module with
DMX digital console to achieve dimming or various changes in procedures.
2.3

Direction for use

DMX address code settings (Instructions for 3 channels):
Each DMX common controller occupied 3 DMX addresses, adopt coding switch set address. It is a Binary
numerical code switch which is setting DMX original address code from 1 to 9. 1 is the lowest, and 9 is
the highest. 511 address codes could be set in all. DMX original address code equal aggregate value of
the coding switch value from 1 to 9. Dial the coding switch upwards (ON is set 1), the value of bit can be
gotten, on the contrary, the value of bit is 0. DMX signal can be received when coding switch FUN (10) =
OFF (ON is set 0).
For example: Look at the following picture, if you want to set 37 as the address code, you can only dial
down the first, the third and the sixth code switch, the aggregate value of coding switch value from 1 to 9
is 32+4+1, that is, the original address code of DMX512 is 37. And the next two channels are 38 and 39.
DMX RGB Controller
6