Cadac SAFARI CHEF 2 6540H0 Instructions D'assemblage page 4

2. Safety Information (continued)
• If there is a leak on your appliance (smell of gas), close the appliance valve immediately, and take it into a fl ame free location where
the leak may be detected and stopped. If you wish to check for leaks on your appliance, do it outside. Do not try to detect leaks
using a fl ame; use soapy water.
• The correct way is to smear the joints e.g. where the cartridge screws onto the
appliance, with soapy water.
• If bubbles form, then there is a gas leak. Immediately remove the gas cartridge
from the appliance. Check that all the connections are properly fi tted. Check that
the seal is in place and in good condition before connecting a gas cartridge(Fig.
4b). Re-check with soapy water after refi tting the cartridge.
• If a gas leak persists, return the product to your CADAC dealer for inspection /
repair.
• Use Outdoors Only.
3. Assembly Instructions
• WARNING: The legs are spring loaded. Opening and closing of the legs must
be done in a controlled manner to avoid personal injury or damage to your
Safari Chef 2.
• To open the legs, turn the unit upside-down and hold the legs down while lifting
each leg individually. You will hear a "click" if the leg(s) has located correctly.
• To fold the legs back, securely hold the leg and push the Leg Release Clip down.
Then push the legs in-ward to its closed position (Fig 5). This needs to be done
sequentially to optimise space. First the Right front leg (1), Then the
Left front leg (2), and lastly the rear Leg (3) (Fig 3b).
• Before connecting the gas supply, fi rstly check that the appliance valve is in the off
position by turning the control knob fully clockwise (See Fig. 1).
• To fi t the Gas Container, fi rst check that the appliance valve is in the off position by
turning the control knob clockwise to its stop (See Fig. 1).
Making sure that the Gas Container is kept upright, screw the container onto the
valve in a clockwise direction until it is fully engaged, hand-tighten only. If the
container is over-tightened, it may damage the container valve.
• Your appliance is now ready for use.
4. Fitting and Changing the Gas Supply
• Check that the burner is extinguished before disconnecting the gas container.
• To disconnect the gas container unscrew the container from the valve. (See Fig 4a)
• Check the Seal before replacing the gas container.
• Change the gas container outdoors and away from other people.
• To refi t a previously used gas container, refer to instructions in Section 3 above. Apply the same care and checking procedures as if fi tting
a new gas container.
Fig. 3a
Fig. 3c
Fig. 3b
Fig. 3d
2 2
OFF
Fig. 1
Fig. 2
Fig. 4a
Seal
Fig. 4b
GB