Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OP-10R / OP-10T | Manuel d'installation et d'utilisation | Installation and user manual |
20
4. Use
4.1 Connecting the Microphone to the
Transmitter
When using the earband microphone instead of
the internal microphone, connect the earband
microphone to the jack MIC INPUT. Thus, the
internal microphone will be deactivated. If re-
quired, cover the microphone cartridge with the
pop shield provided. Put the earband on your
left ear so that the earlobe support will press
against your earlobe from the rear. A clip is pro-
vided to attach the microphone cable to your
clothes.
4.2 Connecting the Earphone to the Re-
ceiver
As a padding for the earphone, wrap the foam
cover around it: Put the earphone with its print-
ed side to the rear into the unprinted pocket of
the cover, wrap the cover around the earphone
and slip the second pocket over it. The printing
will mark the side where the sound is emitted.
Connect the earphone to the jack and attach the
earphone to your ear. For transmitting the
sound to a hearing aid, connect the induction
loop TR-IL instead of the earphone. Put the
loop around your neck. Via a magnetic field, it
will transmit the sound to hearing aids with a
"telephone coil".
4.3 Wearing the unit
To wear the transmitter /receiver, attach the clip
to your clothes (e. g. belt or trouser pocket) or
use the neckband: Pull the loop of the band
over the clip, slide the pushbutton to the de-
sired length of the band and put the band
around your neck. By unlocking the snap con-
nection ( figure on the right), the unit is easily
removed and exchanged against another one.
Publicité
Table des Matières
