Installation; Operation - Opus Technologies OP-10CH2 Manuel D'installation Et D'utilisation

OP-10CH2 | Manuel d'installation et d'utilisation | Installation and user manual |
Immediately unplug the power supply when:
visible damage appears on the charging station
or AC adapter, after a fall or similar event, if you
are not sure about the condition of the unit or
when malfunctions occur.
In all cases, the damage must be repaired by a
specialized technician.
To clean, use only a dry, soft cloth, under no cir-
cumstances chemicals or water.
We are not liable for any resulting material or
personal injury if the devices are used for a pur-
pose other than that for which they were de-
signed, if they are properly used or are not re-
paired by an authorized person. Otherwise, the
warranty will lapse.
When the appliances are permanently
removed from service, they must be pla-
ced in a suitable recycling plant to help
eliminate them.

3. Installation

Connect the charging cradle to the mains using
the supplied power cord. The base is ready to
use.

4. Operation

1) Connect the mains unit to the socket on the
back of the charging station and to a 230 V ~ /
50 Hz socket. The station is then switched on. As
long as a charging compartment is empty, its
operation indicator flashes.
2) Place the transmitter / receiver in a charging
compartment, load contacts facing down. When
positioning it, be sure to push the unit all the
way into the compartment so that it is secure.
During charging, the charge compartment ope-
ration indicator lights continuously.
3) When the battery is fully charged, the corres-
ponding charge lamp turns off. The device can
then be removed from the charging com-
partment.
4) After charging, unplug the power supply to
avoid unnecessary power consumption.
Note:
If a charge indicator flashes during
charging, the charging station per-
forms a self test to protect the batte-
ry.