Loading The Racks; Lower Rack; Cutlery Basket; Upper Rack - Indesit IDL 750 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23

Loading the racks

 Before loading the rack, remove all food residue from the
EN
crockery, leave saucepans and frying pans with burnt-on
residue to soak and empty all remaining liquid from cups and
glasses. After loading the appliance, check that the sprayer
arms can rotate freely.

Lower rack

Arrange the more difficult items to wash using the Loading
examples as a guide and use the collapsible supports* where
needed.
Serving dishes and lids: place these at the sides of the
rack.
Saucepans and salad bowls: always turn these upside
down.
Very deep dishes: position these at an angle.
In order to guarantee the best washing and drying
performance, the surface of the lower rack is more uneven
than that of the upper rack.

Cutlery basket

The type of cutlery basket may vary according to the
dishwasher model.
 Knives and other sharp utensils should be placed in the
cutlery basket with the point facing downwards.
To divide the central basket* into two separate pieces: pull out
the handle. The two detachable side compartments* may be
hooked onto the upper or lower rack.
The two grids* may be positioned in the basket to separate
the cutlery: place the pieces of cutlery into the appropriate
compartments with the handles at the bottom.

Upper rack

Load this rack with delicate and lightweight crockery: glasses,
tea and coffee cups, saucers, small salad bowls, saucepans
and small saucepans that are not too soiled, using the Loading
examples as a guide.
Lightweight crockery: position these dishes so that they
will not be moved by the jets of water.
Mugs and cups: place these on the tip-up
compartments**.
Long sharp knives and serving utensils: place these on
the tip-up compartments**.
Adjusting the height of the upper rack
1
2
3
4
16
In order to make it easier to arrange
the crockery, the upper rack may be
moved to a higher or lower level.
Open the left and right guide rail
stops and pull out the rack; position
it higher or lower as required, slide it
along the guide rails until the front
wheels are in place and close the
stops ( see figure ).
If the rack is equipped with the click
clack handles* ( see figure ), pull
them upwards or downwards to
adjust the height.
Loading examples for the upper rack
Loading examples for the lower rack
Just you Tip-up compartments**
Items that should not be washed in the dishwasher
Wooden items, objects with wooden or horn handles or
glued-on parts.
Items made from aluminium, copper, brass, pewter or tin.
Items made from plastic that is not heat-resistant.
Antique or hand-painted porcelain.
Antique silver. Silver that is not antique may, however, be
washed in the dishwasher using a delicate wash cycle,
provided that it does not come into contact with other
metals.
 When buying crockery and cutlery we recommend that you
check whether it can be washed using the dishwasher.
Washing the handles
*
To wash the upper and lower rack handles: remove the two
fastening plugs, lift out the handles and rinse them under
running water, then fasten them to the rack using the same
plugs.
* Only available in selected models.
** The number and position may vary.
These special tip-up
compartments can be used to
arrange mugs and cups.
Spoons, forks and knives
should be placed in the slots
provided. Stemmed glasses
can be hooked on by threading
the stems into the slits.

Publicité

Chapitres

Table des Matières
loading

Table des Matières