Bigassfans The Garage Light Manuel D'installation page 4

CAUTION: This luminaire must be mounted or supported
!
independently of an outlet box.
CAUTION: Make sure to drill mounting holes in the center of a joist.
!
To hang the light fixture:
1. Locate the ceiling joists. Mark drill locations for the two mounting holes
in the center of a joist and approximately 16" (40.6 cm) apart.
2. Drill holes into the marks using a 3/16" or 4.75 mm drill bit.
3. Install the lag eye screws in the ceiling, and then hang the S-hooks
from the lag eye screws.
4. Hang the fixture from the S-hooks using the eyebolts on the top of the
fixture.
5. Plug in the power supply cord. Note: If the light includes an occupancy
sensor, it may take up to one minute to turn on after installation. The
sensor requires time to warm up.
6. If necessary, use zip ties or cable ties to secure excess power supply
cord length above the fixture or to the ceiling.
2
WWW.BIGASSLIGHT.COM
HANGING THE FIXTURE
Ceiling
cutaway
© 2016 DELTA T CORP.
S-hook
ALL RIGHTS RESERVED.
Lag eye
screw
Eyebolt
Fixture