Mitsubishi Electric City Multi PLFY-P-NLMU-E Manuel D'installation page 4

[Fig. 6.3.1]
"0-0 gas" mark
"OUTER" mark
Refrigerant piping (gas)
Field refrigerant piping
Insulation material
Pull in this direction.
Flare
Move to the original position.
7
[Fig. 7.2.1]
A B
A
A: 25 cm [9-27/32 in]
B: 1.5 – 2 m [4-7/8~6-1/2 ft]
Downward slope of more than 1/100
Insulating material
Metal brace
[Fig. 7.2.3]
D
8
[Fig. 8.1.1]
~208/230 V
L1, L2, G
4
*1
"INNER" mark
Flare insulation (2)
Refrigerant piping (liquid)
Pipe insulation (1)
Flare
Insulation material
There must be no gap.
7.2
[Fig. 7.2.2]
B
Indoor unit
Take as large as possible. About 10 cm [3-15/16 in]
Collected pipes
C: 28 cm [11-1/32 in]
Drain hose (Accessory)
Be sure to use the supplied drain hose (Accessory).
Less than 300 mm [11-13/16 in]
Hard vinyl chloride 90° elbow (field supply)
Hard vinyl chloride (VP-25) (field supply)
Tie band (small) (Accessory)
C
6.3
[Fig. 6.3.2]
(figure showing the flare insulation)
*2
Field refrigerant piping
There must be no gap.
Unit body plate
OUTER
INNER
Unit body
Provided flare insulation (2)
D:170 ± 5 mm [6-23/32 ± 7/32 in]
8.1
Switch 15 A (Breakers for Current Leakage)
Switch 15 A (Breakers for Wiring or Main Switch)
Indoor unit
Total operating current be less than 15 A
Pull box
[Fig. 6.3.3]
20 [13/16]
20 [13/16]
*3
*4
20 [13/16]
Tape (3)
Fasten with tape.
Provided tie band (4)
7.3
[Fig. 7.3.1]
Insert the pump's end 2 to 4 cm.
[13/16 to 1-19/32 in]
Remove the polyethylene plug.
About 1000 cc
Water
Filling port
mm [in]
20 [13/16]