AERTEK AT-918C Manuel D'utilisation page 5

Quick Start
6
Dog Switch Button
Step 6:
Match the receiver and transmitter.
dog mode (Dog1, dog2 or dog00) by pressing the dog switch
button. For the first receiver, choose dog 1 mode and quickly
press one of the three buttons in the front, and the first
receiver will be connected with the transmitter. Meanwhile,
the red light goes off and the blue light starts flashing. If you
have another receiver, turn it on, choose dog 2 mode, press
any function buttons, and the second receiver will be paired.
You can train different dogs separately in different dog
systems. If Dog00 is selected, both dogs will receive
correctional signals.
Tip 3: After 3 minute of inactivity, transmitter will go into sleep
mode. You can wake it up by pressing any function keys.
⑦
-03-
Step 7:
and the receiver beeps. Similarly, press the vibrate button, and
the receiver vibrates. Cap the shock test kit on the metal prongs,
and press the shock button. If the bulb lights up, the shock
function is normal.
: The duration for pressing the beep, vibrate or shock button will
Tip 4
Choose a
lead to difference on the length of the beep, vibration or shock time.
8
Step 8:
rotating the thumbwheel dial. 1-9 levels can be chosen. In
level 0, you can do nothing with the remote.
Step 9:
wear the receiver around dog's neck. Remember to leave one finger
place between the collar and the neck, and then you can train the dogs.
Shock Button
Tip 5:For 918C, auto Anti Bark function is available. Press Dog Switch button
for 3 seconds to enable/disable the auto anti bark mode with the signal
Beep Button
light be solid blue/off. In dog00 system, auto anti bark function is
Vibrate Button
automatically disabled and cannot be turned on. Please turn auto anti
bark function off in a timely manner when the system is not in use.
Check the button functions. Push the beep button,
Adjust the intensity of shock function by
Start to train the dogs. Put the collar into the receiver and
0 9
9 0