Introduction; Set Contents; Transmission Of Your Original Remote Control Signals; Installing The System - Ebode PowerMid Premium Guide De L'utilisateur

2.

Introduction

Thank you for buying the ebode Powermid Premium. This kit allows you to control remotely
any A/V distant appliance, TV, VCR, Hi-Fi, satellite and cable box, just by using your
existing remote control! The remote control signal is transmitted through walls and ceilings,
up to 100 meters away (open field, about 30 meters through walls and ceilings).
Our ebode proprietary eIR
immunity for infrared noise of direct sunlight, CFL lighting and Flat Panel TV's (including
Plasma, LCD and LED). Provides accurate reproduction of the latest generation
Infrared codes that are used in remote controls of, for instance, set-top boxes and media
players (incl. RC5/6, RCMM, XMP).
3.

Set Contents

1 Transmitter: converts IR signals of remote controls into 433.92 MHz RF messages and
transmits them to the Receiver, even through walls and ceilings.
1 Receiver: converts RF messages back into IR signals to control the selected A/V source.
2 Mains power supply wall adapters 230V~50Hz to 9VDC 200mA

4. Transmission of your original remote control signals

Point your original remote control at the PowerMid Transmitter. As soon as you press a
button, the transmitter captures the IR command, converts it into a RF message, and
transmits it through the walls to the PowerMid Receiver. This unit converts the signal into
an IR message back, in order to control the selected A/V source. For example, you can
change channels on your satellite receiver while viewing it in another room. The remote
control signal is transmitted through walls and ceilings, up to 30 meters away.

5. Installing the system

1. Plug the PowerMid Transmitter power supply adapter into a 230V~ outlet in the room
where you want to use your remote control (up to 20 feet/6 meters away from where you
normally sit). Plug the power supply adapter lead plug into the connector at the end of
the cable of the transmitter.
2. Plug the PowerMid Receiver power supply adapter into a 230V~ outlet in the room
where your TV, VCR, Stereo, etc. is located (up to 20 feet/6 meters from it). Plug the
power supply adapter lead plug into the connector at the end of the cable of the
receiver.
3. Point the front of the Receiver towards the TV, VCR, stereo etc.
4. Point your remote control at the Transmitter. It receives the signals and transmits them
to the Receiver. The Receiver then re-transmits these infrared signals to your TV, VCR,
stereo, etc.
28-2-2012
x (pronounce Irex) Technology guarantees a high level of
2 TM
5 Powermid Premium