System Requirements; Hardware Description; Hardware Installation - König Electronic CMP-CARDRW43 Mode D'emploi

Features:
• 3.5" internal card reader (plastic)
• Fully supports: T-Flash, XD , MS Select CF1, CF-II , Extreme CF, ExtremeIII CF, Ultra II CF, HS CF, SD
HC, SD, Mini SD, Extreme SD, ExtremeIII SD, Ultra II SD, MMC1, MMC-II, RS-MMC, MMC 4.0, Ultra
MMC, HS RS MMC, MS, MS Pro, MS Duo, MS Pro Duo, Extreme MS Pro, ExtremeIII MS Pro, Ultra II MS
Pro, MS-MagicGate, MS-MG-Pro, MS-MG-Duo, MS-MG-Pro-Duo, MS-ROM, HS MS-MG Pro, HS MS-MG
Pro Duo, USB-HUB;
• Supports Windows ME, Windows
®
• Directly and quickly browse and edit the files in the flash driver
• It is very easy to download or upload with high-speed transfer rates up to 480mbps
• No need for any extra power source
• Hot-swap supported
• There is a LED showing the status during reading and writing
• No need to install drivers

System Requirements:

• Windows ME/2000/XP/Server 2003/Vista
®
• Available USB connection on main board

Hardware Description:

1) MS connection
2) CF/MD connection
3) USB2.0 connection
4) SD/MMC connection
5) XD connection
6) T-F connection
7) Active LED
8) Read/write LED

Hardware Installation:

• Turn off the power to your computer.
• Unplug the power cord and remove your computer's cover.
• Remove a 3.5" front cover bracket from the computer case.
• Fasten the card reader with 4 screws in the 3.5" bay.
• Connect the USB cable from the card reader to a free USB connection of the main board.
• Replace the computer cover and reconnect the power cord.
USB cable connections:
1) + 5V
2) + 5V
3) USB -
4) USB -
5) USB +
6) USB +
7) Ground
8) Ground
9) NC
10) Key
ENGLISH
2K/XP, Mac OS 9/X, LINUX4.0 or higher
® ®
Card reader
USB Connector
2
Mainboard
USB Connector