Hama TS38G Mode D'emploi page 9

6.2. Selecting the channel/Other measuring stations
Note
• Ensure that the base station and measuring station are set to
the same channel. Suitable base stations can be found at www.
hama.com
• The transmission channel on the supplied measuring station can be
changed/set (CH1, CH2, CH3).
• The measuring station is suitable for the following base stations:
186314, 186420
6.3. Low battery charge
Measuring station
If the batteries need to be replaced, the symbol for low battery charge
will appear next to the outdoor temperature display on the base
device. Replace the batteries immediately.
Note – Replacing the batteries
• Note that the stations have to be resynchronised each time after
you change the batteries in the measuring or base station.
• To do this, remove the batteries from the other station and then
reinsert them, or change them as required.
7. Care and Maintenance
• Only clean this product with a slightly damp, lint-free cloth and do not
use aggressive cleaning agents.
• Make sure that water does not get into the product.
7