Cleaningand Maintenance; Safety Instructions; Daily Maintenance - Casselin CG180S Mode D'emploi

Masquer les pouces Voir aussi pour CG180S:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
Press '-' and '+' simultaneously again (2 beeps).
The time flashes, you can set the desired time with '-' and '+' (0.1 - 19.59 mm).
Wait for the screen to go off then press '-' to start the timer.
5 beeps to signal the end of the timer.
REMARKThe appliance is fitted with a safety system in the event of overheating. If triggered, unplug the
device and allow it to cool. If this protection system operates regularly, it is imperative to contact your dealer.
After automatic shutdown, the device can only be put into service by pressing the Reset button on the back
of the device, wait for the temperature to drop, press the Reset button.
6. CLEANING AND MAINTENANCE

6.1 Safety instructions

All maintenance, cleaning and repair of the appliance must be carried out with a disconnected appliance
(isolated from all electrical sources).
The use of caustic detergents and baking soda for cleaning is prohibited. Water must not get inside the
device.
Never immerse the device in water or other liquid.
Use Casselin brand products intended for this purpose.
WARNING
The device cannot be cleaned with a direct water jet (no pressurized water jet).

6.2 Daily maintenance

Unplug the device
Clean the device with hot water and a clean cloth after each use
After cleaning, use a soft, dry cloth to polish and dry the device. All parts must be dried.
Store the device in a dry place.
6.3 Safety instructions for maintaining the device
Daily check for damage to the power cord. Never use the appliance when the cord is damaged. If the cord is
faulty, it must be replaced by a qualified technician.
In the event of a fault, contact your dealer.
Any maintenance or repair must only be carried out by a professional.
REMARK
In the event of a fault, unplug the appliance, let it cool down and contact your dealer. If the device does not
start, check your power cord. The device should not be plugged into a multiple socket, but directly to a wall
outlet. For any other anomaly, contact your dealer.
REMARK
Waste from used devices: any used device must, when disposing of it, comply with the regulations in force
in its country *. It is essential to make the device unusable before its disposal by removing the power supply
cable.
* in terms of ecology and recycling
EN

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Cg180dCg180rs

Table des Matières