LENCO EPB-030 Mode D'emploi page 8

charge it for 2 to 3 hours, the LED indicator changes from red to blue
when it is fully charged.
To maintain the life and performance of the battery, the battery may
need to be charged if the earphone is not used for some time. Charge the
battery at least once a month.
To charge the earphones, you can connect the supplied Micro USB cable
to the Micro USB connection (5), you can connect this to a USB home
charger (not included) or a device with a USB charging function.
C. Power ON/OFF
 Long press (3 seconds) the "
LED indicator will change to blue flashing and then to blue red flashing
alternately
 Long press (3 seconds) the "
led indicator will change to Red)
D. Bluetooth connection
1. After you have switched on the headphones, the LED indicator
changes from blue flashing to blue/red flashing alternately.
Now the earphones are ready to pair with your Bluetooth device.
2. Then activate the Bluetooth function in your Bluetooth device, The
Bluetooth device automatically searches for other Bluetooth devices.
3. Your Bluetooth device should show
you can select it for pairing. For some Bluetooth devices, you may
need to input "0000" as pairing password.
4. If the devices are successfully paired, you will hear a tone and the LED
indicator will flash blue slowly
5. Note: For saving battery energy, the Bluetooth earphone will turn to
off mode automatically when no device is in paired in 8 minutes.
E. Disconnect from paired device
1. Turn off the Bluetooth earphone.
2. You can also choose to end the Bluetooth connection on your
Bluetooth device. The LED indicator will, The LED indicator will flash
blue/red again alternately, You can now connect to another Bluetooth
device
(2)" button to turn On the device (The
(2)" button to turn Off the device (The
"Lenco EPB-030"
8
in list, and then