Blaupunkt BLP3923 Mode D'emploi page 13

Powering the speaker
Press the power switch to the ON position to power the speaker on.
A tone will be heard, the lights will turn on, and the speaker will enter Bluetooth pairing mode.
Press the power switch to the OFF position to power the speaker off.
Using the lights
Power the speaker on and press the LED switch to the ON position to turn on.
Press the LED button to cycle through the light modes. For best results with the reactive lights modes,
increase the volume of your paired or connected device.
Press the LED switch to the OFF position to turn lights off.
Playing music
To listen music on your speaker make sure it is paired to a Bluetooth-enabled device (see the Bluetooth
Pairing section) or connected to a wired device, using the 3.5 mm auxiliary input jack (see Using with a
Wired Device section).
Bluetooth pairing
1. Power the speaker ON. A tone will be heard and the LED indicator will quickly flash green.
2. Set your mobile device to search for Bluetooth devices. When it appears, select BLP3923 from the list.
3. After a successful pairing, a tone will be heard and the LED indicator will turn to green.
Use the controls on your connected device for playback and volume adjustment.
Using with a wired device
Insert AUX cable into the AUX input jack on speaker. Insert the other connector into the headphone jack on
your media-playing device.
Use the controls on your connected device for playback and volume adjustment.
Using the mic
Insert a standard 1/8" connector of a wired microphone (not included) into the microphone input jack on
the back of the speaker. Use the mic volume knob to adjust mic volume.
Mounting the speaker
The speaker can be mounted on any conventional stand mount with a maximum shaft diameter of 1.45".