Publicité
Les langues disponibles
Les langues disponibles
English
1.
To fix the tool holder to the machine,
introduce the shank and use the pin for
the positioning. Then tighten the 2 screws
of fixations (Important, make sure that the
screws have the same strength of
tightening).
2. Settle the offset of the position.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
SR20J-RSC-007
3.
4. The diameter of tail of a tool of cup
MARK :
positions. Use the supplied corks.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation : 23.02.17
During the assembly or the dismantling
of your tools of cup, to block the brooch
on dishes planned for that purpose, by
using a key forks adapted.
never has to have a difference
furthermore of 0.4mm with regard to the
diameter of the crowbar. Example: Ø of
crowbar 9.5mm - Ø tail 9.1 minimum.
never use the chuck with empty
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document :
SR20J-RSC-007
Mode d'emploi 1-
Page : 2 de 4
Publicité
