Roxio GAMECAP Guide De Démarrage Rapide

Game console component cables (NOT INCLUDED)
A B
Power off Xbox® 360 or PlayStation® 3. Connect a console specific
Component AV cable* to the A/V port of the console. For
PlayStation 3, you can leave the HDMI cable plugged in if you
would like. For Xbox 360 the HDMI may need to be removed to
make room for the Component AV cable. Next, plug the color
corresponding Component Video and RCA Audio cables to the
inputs on the Roxio GameCAP device.
*Console specific Component AV cable(s) are NOT INCLUDED.
PlayStation3
If you were using HDMI or
Composite AV cables on your
PlayStation 3 you will need to
reset the video output for
Component AV cables by
following these steps:
Switch to Component/D-Terminal option
C
and confirm the change
F
Select "Set Audio Output Settings"
Xbox 360
Use the remote control for the TV
•
to change the input to Component
Quick Start Guide available in French, German, Italian, Spanish & Dutch here:
Schnellstarthandbuch hier auf Französisch, Deutsch, Italienisch, Spanisch und Holländisch verfügbar:
Guía de inicio rápido disponible en francés, alemán, italiano, español y holandés aquí:
Guide de démarrage disponible en français, allemand, italien, espagnol et néerlandais ici :
Guida introduttiva disponibile qui in francese, tedesco, italiano e olandese.:
Handleiding Aan de slag hier beschikbaar in het Frans, Duits, Italiaans, Spaans en Nederlands:
C
COMPONENT VIDEO IN AUDIO IN
Y Pb Pr. L R
A
B
C
A
Go to Display Settings
D
Use your TVs remote to change input to Component
Check ALL the supported resolutions that your TV supports
(480p/720p/1080i etc.)
G Change Audio to Audio Input Connector/SCART/AV MULTI
Tips:
• If you are not able to see the preview video in the Roxio Game Capture software, power off and then power
on the console. The video signal should reset after you power back on.
• If your Xbox 360 comes with a hybrid A/V cable, make sure the switch the cable to "HD" mode.
D
Game Capture Quick Start Guide
Connect the color corresponding
Component Video cables between
the outputs of Roxio GameCAP device
and the Component Video inputs at
the back or side of your TV.
E
D
Connect the color corresponding
RCA Audio cables between the
outputs of Roxio GameCAP device
and the Component Video inputs
at the back or side of your TV.
B
Select Display Settings/Video Output Settings
E
Select (X) Enter to confirm change
H
Select (X) Enter to confirm change
www.roxio.com/gamecap/guide
E
Connect USB cable
between the output
on the Roxio GameCAP
device and the USB2.0
port of your laptop or PC.
©2011 Sonic Solutions. Printed in the USA. 540990-00CA