Overheating Protection - AEG HL 5517 Mode D'emploi

English
24
Instructions
Unpacking
• Remove any protective foils and transport packaging
from the device that may be present.
• Unwind the cable completely.
Electrical connection
• Make sure that the iron voltage (see name plate) and
the line voltage match.
• Turn the switches to 0 and the lowest level.
• The mains plug should only be inserted into a cor-
rectly installed 230 V ~ 50 Hz socket with earthing
contact.
Connected Wattage
The device can consume 2000 Watts:
With this connected load a separate supply line pro-
tected by a 16 A household circuit breaker is recommen-
ded.
CAUTION: OVERLOAD
• If you use extension leads, these should have a
cable cross-section of at least 1.5 mm
• Do not use any multiple sockets, as this device is
too powerful.
Function Switch
0 = OFF
= Cold air
I = Hot air (1000 W)
II = Hot air (2000 W)
NOTE:
Select low power, for example, for a small room. If this
is not enough, please switch to the high level.
Levels/Heating Power
By regularly switching the radiator on and off , the
thermostat ensures that the desired temperature is
maintained.
Lowest level
05-HL 5517 AEG.indd 24 05-HL 5517 AEG.indd 24
In order to fi nd the ideal thermostat setting, please
proceed as follows:
• Turn the thermostat control to the highest level.
• As soon as the desired temperature has been reached,
turn the thermostat control slowly down until the
radiator turns itself off . The control lamp on the
switch goes off .
• The radiator will now automatically stay at the
desired temperature.
CAUTION:
When the device is no longer being used you should
always remove the mains plug.
Cold air operation
If you would like to use the device as a ventilator please
move the function switch to the ventilator symbol and
turn the temperature control to the highest position.
Turning Off
If you would like to switch the device off , turn the
switch to the lowest level or 0 and then remove the plug
from the socket. The control lamp goes off .

Overheating Protection

2 .
• The device is equipped with an overheating protec-
tion that switches the device automatically off in
case of overheating. Shift the function switch to „0"
position and pull out plug out of the socket. Let the
device cool down for about
10 minutes before using it again.
• Should the overheating protection shut the device
off again shortly after, there is probably a defect.
Switch off the device again and pull out the plug. Let
the device be checked by an authorized dealer or by
our customer service (or contact your dealer).
Cleaning
WARNING:
Always remove the power cable from the socket and
allow the radiator to cool down before cleaning it.
CAUTION:
Do not use any type of detergent, abrasive or polish
on the housing of the radiator as this may damage the
surface.
Highest level
• Wipe off the radiator with a dry cloth in order to
remove dust.
• A damp cloth (not wet) can be used to remove stains.
27.08.2008 8:59:30 Uhr 27.08.2008 8:59:30 Uhr