BEAUTY JATA MP525 Instructions D'usage page 14

MAINTENANCE AND CLEANING
• Before doing anything, make sure the clipper is unplugged from the mains.
• Use the brush to take off rests of hair in the blade.
• In case the blade has been dismantled for its replacement or cleaning, it must be adjusted again.
To do so, slacken lightly the screws placed at the bottom of the blade
• Use your fingers to move horizontally the blade until the ends are in perfectly aligned.
• The tooth of the up blade must be moved back 1, 2 mm. approximately, with regard to the tooth
of the down blade
• Use a slightly damp cloth to clean the outside of the appliance.
• Do not use in cleaning chemical products or abrasives, metallic scourers and similar, which may
deteriorate the surfaces.
ENVIRONMENT PROTECTION
• Dispose the appliance according to the local garbage regulations.
• Never throw it away to the rubbish. So you will help to the improvement of the
environment.
• Always working your way from the back of the head, gradually cut the
hair, shorter each time by reducing the space between the comb or your
fingers to the hair. Frequently comb your hair to check for any differences
in its length and to eliminate the hair which has already been cut.
Fifth step: THE FINAL TOUCHES
• Do not use any guides for the final touches.
• To get an exact hair cut, and the side burns, nape and the area around
the ears with straight lines, turn the hair clippers round and place them
at a straight angle with your head so the blade is in slight contact with
the skin, and shave downwards. This way you will get a perfect finish, as
if shaving.
ADJUSTABLE LEVER
• You can use the adjustable lever for finished and retouched, specially
round the neck and ears.
• To increase the cut distance put down the lever.
• To reduce the cut distance put up the lever.
TRIM THE BEARD
• Always remember you must begin with the
longest cutting guide (12 mm.) before using one
of the shorter guides.
• Start by cutting from below the chin and moving
the clipper with soft movements upwards and
outwards.
• For the final touches and the edges always use
the hair clipper without any guide.
REVISION OF MUSTACHE
• Comb the moustache downwards.
• Start with the higher cutting guide. Later you
may use the shorter cutting guides.
14