Fan Assembly - evatronic FSD-40A Manuel D'utilisation

11. Connection pole
12. Cabinet with control panel
13. Locknut for cabinet
14. Locknut for lifting
15. Base Stand
16. LED diode panel
17. Controls buttons ( ON/OFF and timer)
18. Lift tube
19. Stand post tube
20. Heavy base
21. Press plate
22.Bend bolt

FAN ASSEMBLY

Unpack all parts of the fan and remove all parts of the packaging, taking care not to
throw away small parts.
Step n°1: Assembly of the support (base and foot)
1. Assemble the base (part n°15) with the heavy base (part n°20), set the fixed and
metallic tube in the hole of the base, to fix the tube and the base with the heavy base,
tighten the round plate (part n°21) with the L-shaped screw ( part n°22)
2. Install the main part with the motor on the metal tube by tightening screw n°13.
Step n°2: Assembly of the 5-blade propeller on the engine part
1. Assemble the rear grille to the engine part by screwing part No. 5 to fix the grille.
2. Put the 5-blade fan (part 4) on output motor shaft ( part 7) and screw part 3 to lock
the 5-blade fan.
3. Position the ring (part #2) on the rear grid (part #6), once the ring is properly
positioned on the rear grid, place the front grid (part #1) and tighten the circle clamp
with a screwdriver to secure the front and rear grids together.
USE
Place the fan on a flat, dry and stable surface.
Connect the fan to an outlet.
Press On/Off to start the fan:
The fan switches to slow speed (L).
If you want to change gears, press a second time to reach the average speed (M), a
third time to get the fast speed (H).
If you press the off/off button a fourth time, the fan will stop.
The LEDs L H R light up according to the selected speed.
To swing the fan from left to right, press the button (10). To stop the oscillation, the
button must be raised again.
13/21