Hitachi CG47EJ Mode D'emploi page 9

Installation of blade guard(Fig. 1-8, 8B, 1-8D)
Fix the guard bracket to the side the angle
transmission (Fig. 1-8D).
Install the blade guard on drive shaft tube
against angle transmission. Tighten the guard
bracket firmly so that the blade guard does not
swing or move down during operation.
CAUTION!
Some blade guards are equipped with sharp line
limiters. Be careful with handling it.
GB-8
SW.
Fig. 1-8
Fig. 1-9
When using a trimmer head (2) with two piece
type blade guard, attach the guard extension to
the blade guard. (Fig. 1-9)
NOTE!
If your unit has guard location label on drive
shaft tube, follow the indication.
NOTE!
To remove the guard extension, refer to the
drawings. Wear gloves as the extension has a
sharp line limiter, then push the four square tabs
on the guard one by one in order. (Fig. 1-9C)
CG47EJ (T)
Fig. 1-8B
Fig. 1-9C
Fig. 1-8D