Care And Cleaning - Black & Decker CO100B Guide D'utilisation Et D'entretien

US IN G T H E B OT TL E OP E N ER
1. Grab the bottle to be opened and position the
cap above the lip on the back side of the bottle
opener.
2. Tilt bottom of the bottle away from you to catch
the cap on the lip and open the bottle. (O)
US IN G T H E B AG C UTTE R
1. Grasp the plastic or metal foil bag to be opened by one corner, with one
hand holding the top edge and the other hand holding the side or bottom,
depending on the size of the bag.
2. Position tightly pulled corner of bag against the
cutter and pull firmly to the left to open the bag.
Note: Pulling a bag straight against the cutter will cut
a line along the top of the bag; pulling at an angle will
simply remove the corner. (P)
CA R E A N D CLEA N IN G
This product contains no user serviceable parts. Refer service to qualified service
personnel.
Important: Unplug the cord before cleaning the unit.
REMOVING BLADE ASSEMBLY
1. Lift the piercing lever up as far as it will go
(roughly 90 degrees)
2. Carefully grip the blade assembly and pull it away
from the can opener. (Q)
3. Wash with water and dish soap and dry
thoroughly. Do not put the blade assembly
in the dishwasher.
4. Before replacing the blade assembly, wipe the can
opener body, knife sharpener and area around the
geared wheel with a slightly damp cloth or sponge.
REPLACING BLADE ASSEMBLY
1. Align key post on the blade assembly with key
slot on the unit. (R)
2. Push in blade assembly and turn clockwise until it
locks into position. (S)
O
P
Q
R
S
11