Lifting Instructions - Onda EKC Manuel D'emploi

SAFETY RULES
Road consignment note rules apply for carriage across the
frontier. All our contracts are subject to Italian Law and
may only be challenged before an Italian Court.
ONDA heat exchangers are nitrogen pressurized and
labeled as such in order to avoid humidity issues and in
order to control their watertightness after transportation.
After the heat exchanger has been delivered, it is necessary:
• to check that the it is under pressure by using the
Schräder Valve;
• to check if the heat exchanger was damaged during
transportation. If so, it is necessary to inform the carrier;
• other possible defects must be indicated on the
International Consignment Note at the time of takeover;
• if defects are not externally visible, delivery notes are
regularly signed as acknowledgement of receipt;
• we consider possible claims submitted within a week
following the delivery, only if the consignee is able to
demonstrate that goods had been damaged during
transportation;
• if it is not externally verifiable and if the consignee
doesn't submit a written claim to the carrier within a
week following the delivery, in which the claim is precisely
stated, the carrier is thought to have delivered goods in
the same condotions at the time of takeover;
• ONDA S.p.A. undertakes no responsability for additional
charges due to heat exchangers installation and
adjustment.
handbook
UNIT COOLERS
AIRCOOLERS
If heat exchangers have to be temporarily stockpiled,
choose a dry, clean and vibration-free place at a medium
temperature and with reduced humidity.
Follow the manufacturer's instructions about the duration
and frequency of stored fans and electric motors
inspections while being stockpiled. We advise to test the
ventilation system every three months for several hours.
When heat exchangers are collected from storage room, it
is necessary to check their watertightness before installing
them.
Heat exchangers are fitted with supports (in order to make
it easier to transport them) must be hauled by means of a
cantilever crane (see lifting instructions).
Detailed lifting instructions are provided for every product.
Heat exchangers must be lifted and hauled carefully by
skilled professionals. Safety must always be ensured. If you
have any doubts about appropriate lifting procedures, do
not hesitate to ask ONDA S.p.A.
Provided instructions must be strictly followed in order to
avoid damage to the products.
Heat exchangers assembled on a wooden frame can be
hauled by means of a forklift. Stockpiled heat exchangers
must be hauled one at a time. Yhey can also be hauled by
means of a crane, by letting belts move under the wooden
frame.

LIFTING INSTRUCTIONS

9