Power Cord Connection; Battery Warning - Sun Microsystems Sun Fire E2900 Guide D'installation

Masquer les pouces Voir aussi pour Sun Fire E2900:
Table des Matières

Publicité

SELV Compliance
Safety status of I/O connections comply to SELV
requirements.

Power Cord Connection

Caution – Sun products are designed to work
with power systems having a grounded
neutral (grounded return for DC-powered
products). To reduce the risk of electric shock,
do not plug Sun products into any other type
of power system. Contact your facilities
manager or a qualified electrician if you are
not sure what type of power is supplied to
your building.
Caution – Not all power cords have the same
current ratings. Household extension cords do
not have overload protection and are not
meant for use with computer systems. Do
not use household extension cords with
your Sun product.
The following caution applies only to devices with a
Standby power switch:
Caution – The power switch of this product
functions as a standby type device only. The
power cord serves as the primary disconnect
device for the system. Be sure to plug the
power cord into a grounded power outlet that
is nearby the system and is readily accessible.
Do not connect the power cord when the
power supply has been removed from the
system chassis.
The following caution applies only to devices with multiple
power cords:
Caution – For products with multiple power
cords, all power cords must be disconnected
to completely remove power from the system.
xvi
Guide d'installation des systèmes Sun Fire E2900 • Juin 2006

Battery Warning

Caution – There is danger of explosion if
batteries are mishandled or incorrectly
replaced. On systems with replaceable
batteries, replace only with the same
manufacturer and type or equivalent type
recommended by the manufacturer per the
instructions provided in the product service
manual. Do not disassemble batteries or
attempt to recharge them outside the system.
Do not dispose of batteries in fire. Dispose of
batteries properly in accordance with the
manufacturer's instructions and local
regulations. Note that on Sun CPU boards,
there is a lithium battery molded into the
real-time clock. These batteries are not
customer replaceable parts.
System Unit Cover
You must remove the cover of your Sun computer system
unit to add cards, memory, or internal storage devices.
Be sure to replace the cover before powering on your
computer system.
Caution – Do not operate Sun products
without the cover in place. Failure to take
this precaution may result in personal injury
and system damage.
Rack System Warning
The following warnings apply to Racks and Rack Mounted
systems.
Caution – For safety, equipment should
always be loaded from the bottom up. That is,
install the equipment that will be mounted
in the lowest part of the rack first, then the
next higher systems, etc.
Caution – To prevent the rack from tipping
during equipment installation, the anti-tilt
bar on the rack must be deployed.

Publicité

Table des Matières
loading

Table des Matières