Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Equipment required: Sat Receiver OR... and TV set or selective measu-
ring device WA ... .
Visual adjustment via TV set and SAT-Receiver
1. Connect the TV set to the satellite receiver with the SCART
cable.
2. Press the AV-button on your TV remote control.
3. Preselect the program place for your tv program (ARD) on your
satellite receiver..
4. Connect the SAT receiver to the LNC port (Quadro= LH)
5. Set the antenna to the satellite and adjust elevation and azimuth
(rotation). Check wether ARD appears on your TV set. Refer to the
elevation skale on the bracket.
Noisefree screen: Finally tighten all screws.
Adjustment with measuring device WA ...
ARD transponder at 11.494 GHz. LO = 9.75 GHz,
IF = 1744 MHz.
1.Set 1744 MHz on your WA ... and connect to the LNC port (Qua-
dro = LH).
2.Switch on the operating voltage at WA ... and set to maximum
on WA ... .
Polarization decoupling.
Loosen the screws and turn the feed slightly until noisefree screen
(maximum at WA ... is achieved).
ASTRA 19,2° HOTBIRD 13°
(GB)
1744
OR...
TV
- 7 -
Publicité
Table des Matières
