Monacor LEDS-1SET/RGB Mode D'emploi page 9

To run through the control programmes succes-
sively, press the button AUTO (6). The programmes
with the LEDs constantly lighting are skipped.
To switch between different programmes, the
buttons MODE (5) can also be actuated. From the
programme constant lighting in red it is possible to
switch with the button MODE
ning through all programmes.
5.3 Brightness, speed, pause, reset, on / off
1) To adjust the LED brightness, actuate the but-
tons BRIGHT (9). 9 levels are available. How-
ever, the brightness can only be adjusted for the
programmes change of colour, flashing and
constant colour. For the remaining programmes
the brightness is exclusively defined by the pro-
gramme.
2) Adjust the running speed with the buttons
SPEED (7). Nine speed levels are available.
3) The button PAUSE (11) allows to stop and
restart the run of the control programme.
4) By keeping the button RESET (12) pressed for
a few seconds, the control is reset to the initial
state. Then the brightness of the LEDs is set to
the maximum value and the running speed to
the medium value and the unit is switched to the
function running through all programmes.
5) The button OFF (8) allows to switch off the
LEDs and the button ON (4) to switch them on
again.
After operation, switch off the LEDs with the
button OFF. If the lighting strip will not be used
for a longer time, disconnect the power supply
unit from the socket. Even if the LEDs are
switched off, there is always a low current con-
sumption.
All rights reserved by MONACOR
may be reproduced in any form or by any means for any commercial use.
to the function run-
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual
6 Specifications
Type and number of LEDs: . . 36 RGB LEDs
Power supply: . . . . . . . . . . . . 12 V via supplied
Ambient temperature: . . . . . . 0 – 40 °C
Dimensions
LED strip: . . . . . . . . . . . . . 10 × 900 mm
controller: . . . . . . . . . . . . . 35 × 22 × 50 mm
remote control: . . . . . . . . . 40 × 7.5 × 86 mm
Subject to technical modification.
PSU connected to
230 V~ / 50 Hz
GB
9