Publicité
Liens rapides
⊿01
Applicable : BRZ (13MY~)
REAR SIDE UNDER SPOILER
INSTALLATION INSTRUCTION
GUIDE D'INSTALLATION
EINBAUANLEITUNG
MANUALE D'INSTALLAZIONE
MANUAL DE INSTALACION
PART.No
E5610CA100
①
②
③
④
⑤
⑥
×１
×４
×４
×２
×２
×２
pattern set
⑦
pattern
ＡＲＨ
pattern
ＡＬＨ
pattern
pattern
ＢＲＨ
ＢＬＨ
×１
＋
6mm
3mm
19mm
Reason of revision
Date
Δ
Addition of work by Rear bumper specification difference.
01
2017.10.24
171024
SUBARU CORPORATION
(1)
Publicité
Manuels Connexes pour STI E5610CA100
Sommaire des Matières pour STI E5610CA100
- Page 1 ⊿01 Applicable : BRZ (13MY~) REAR SIDE UNDER SPOILER INSTALLATION INSTRUCTION GUIDE D'INSTALLATION EINBAUANLEITUNG MANUALE D'INSTALLAZIONE MANUAL DE INSTALACION PART.No E5610CA100 ① ② ③ ④ ⑤ ⑥ ×１ ×４ ×４ ×２ ×２ ×２ pattern set ⑦ pattern ＡＲＨ pattern ＡＬＨ...
- Page 2 ＜CAUTION＞ (1) Perform installation properly according to the procedures indicated in the instruction manual. Improper installation can result in damage to your vehicle or serious injury. (2) Be careful when driving after installing this product as ground clearance at the wheel arch and center section is decreased by approximately 1 cm (0.4 inches) and 4 cm (1.6 inches) respectively.
- Page 3 NOTE: Do not wash the vehicle for 24 hours following installation of this product. If this product requires cleaning after installation, wipe with a soft cloth or sponge with mild detergent and wipe thoroughly with a dry cloth. Do not use gasoline, thinner, acid, alkaline or other solvent based products. The recommended adhesive surface temperature range is 77 F - 104 F(25℃...
- Page 4 With hole pattern ⑦ Ａ Attach pattern A to the bumper edge, and then mark to the intersection on the pattern sheet. 3mm→6mm No hole Recessed locator (φ2mm) pattern ⑦ Ａ Attach pattern A to the bumper edge, and then mark to the intersection on the pattern sheet.
- Page 5 ② ⑤ SECTION SECTION Bumper Bumper ② ⑤ ② ② Apply a piece of masking tape above pattern B as pattern ⑦ Ｂ shown in the image. This piece of masking tape will be used to determine the vertical position of the under spoiler.
- Page 6 Peel 30mm of the tape liner, and seal with tape on the outside of the Rear side under spoiler. ③ Tighten the screws temporarily. ⑥ ④ Please use new clip included in this kit.
- Page 7 Rear Bumper Masking Tape marking １ ２ Top edge of rear side under spoiler ３ ①Rear side under spoiler Set the Rear under spoiler on the Rear bumper SEIKQ along the piece of masking tape.The top edge 4.5 kg of the side under spoiler should meet with the 10 sec (10 lbs) bottom of the masking tape.